Review of K10513 Super Heroes Marvel Hukkrustar MK44 Building Blocks on 5th Dec.

By From The Pubic of Wechat December 6th, 2022 1097 views

Hello ,This is the Anti-Hulk MK44 semi-perspective Mech of K Box, and also the Anti-Hulk MK44 2.0 version that players are very interested in. For those who have not seen 1.0, here is a quick introduction to the portal.

The box already shows that this one is special; Basic information, up to 4,183 pieces.

The box is made of heaven and earth cover series. The design center line of the inner box is divided into two different silhouettes, and the back is divided into A and B.

There are A lot of things to open Box A first:
Special parts are individually packaged and the finish is well protected

The helmet part is made up of three parts.

The luminescent pieces in there light up, the effect is really good

The first package can find two different colors of bolts, among which the dark red is the same color as the dark red of the anti-Hulk, but there is no hint to distinguish the place, I consulted the manufacturer here, in fact, which color is the same, the big red is the injection molding version, the dark red is the injection molding after the rolling spray once. Therefore, the dark red must be thicker than the big red. Finally, I chose the dark red, but the paint was easy to fall off when installing the latch. Fortunately, it did not affect the final product.

A sticker, the use of transparent paste, leafing through the instructions of the sticker step is the last page, it is suggested that you look in advance, can be appropriate in the middle step to complete the corresponding sticker.

The first step of the manual is from the body, the manual uses the effect of shrinkage, seems to be insufficient optimization, a little difficult to match.

The Package 2:
The gold and silver parts are painted.

The parts in the first two steps have completed the body parts. The normal red half is a conventional one, while the perspective half is a special one. The kinds of parts used in the piecing are complicated, and it is difficult to find the parts.

The Package 3:

The details of the foot are a little different from the 1.0 version. There is also a specification error that a short latch installed in step 183 will cause installation interference in Step 219. I simply removed the short latch, so the main structure will not be affected much. At the same time, when completing the third step, the parts in the package of the fourth step will be used. There are still the same problems in the follow-up. This subcontracting is really quite chaotic.

To open Box B:

The Package 4:

The color difference of the red parts is very small. The parts are painted red parts, and the whole leg is mainly decorated with red, gold and silver.